Corny service

[Brewer]

Hi I am looking to service my cornelius kegs but looking for advice, I have 2 sorts of prv pls see pictures...





Can someone guide me what seals are required for these?

I would also like to no where I can get the other seals for posts, dip tube and lid etc

Thanks

[barneey]

Have a look here

viewtopic.php?f=6&t=60426&p=636080&hilit=orings#p636080

Hi guys,

I am putting together this guide for those of you who wish to replace your keg o-rings with silicone ones. You can buy them in packs of 50 from ebay. Some I this info is from other forums and some I've found out myself.

This is the size chart from the vendor I have used

I will list the application and size number

Post #111
Dip Tube #109
Lid #417

There are two gaskets in each quick disconnect that can be replaced
Quick Disconnect small #007
Quick disconnect large #013

Generic pressure relief valve like #104


Generic poppet valve like this #105

http://stores.ebay.com.au/Oringsandmore ... 0601653446

[Matt12398]

Don't the PRVs seal on the little rubber piece on the end rather than an o ring. I thought you had to replace the whole thing?