Is this correct please need to no filter height

[trickybrew]

Guys I have a new boiler but I need to no if the filter height is correct, it looking about 3cm but when I fill it up to the hole, it take 4 liters, is this correct it's a lot to me, is the hole to high! Need to no if I have to contact the seller and say if it wrong,
How can this be its a 56L pot, but I'm only brewing up for 20L FG, what difference between brewing up half a pot or full boil I'll still be out on 3/4 liters out,that's with the hops in the base of the pot after, if its got a filter in the bottom then why is the filter not on the base of the pot???

[jack_c]

By buffalo 40l tap is maybe 2cm from the base and I use a similar filter to you. There will be a dump load of trub and hop material from the boil in there. Should be fine. When draining I angle the boiler and get most/all wort out. If worried you could use a 90degree pickup to lower the filter though...

[jack_c]

Do you use brewing software? E.g., you dial in your kettle size and desired volume into the fermenter and it will account for kettle to fermenter loss etc

I brew to 25l into the fermenter but use maybe 33liters total water, the 8 liters are absorbed in grain, absorbed in hops, lost in kettle trub etc.