Shank help
Shank help
Hi, can anyone shed some light as to what size this John guest fitting may be, the tap shank and fitting all came as one unit so I do not know the size, I have measured it and its 7/8" all day long but the John guest website says they don't even make that size fitting, if it helps the tap is a perlick 650 ss, I need the new John guest fitting as the other has cracked due to over tightening.
- Attachments
-
-
-
-
barneey
- Telling imaginary friend stories
- Posts: 5423
- Joined: Mon Jul 25, 2011 10:42 pm
- Location: East Kent
Re: Shank help
Beer tap fitting if English will normally be 1/2" bsp, if American they will most likely be American Beer thread which is 5/8"
https://en.wikipedia.org/wiki/British_Standard_Pipe
5/8 = 22/3mm across the male part.
so if you have measured 7/8 = 22.225mm
https://en.wikipedia.org/wiki/British_Standard_Pipe
5/8 = 22/3mm across the male part.
so if you have measured 7/8 = 22.225mm
Hair of the dog, bacon, butty.
Hops, cider pips & hello.
Name the Movie + song :)
Hops, cider pips & hello.
Name the Movie + song :)
Re: Shank help
Thanks for the info, what type thread would it be if it's American ??
-
barneey
- Telling imaginary friend stories
- Posts: 5423
- Joined: Mon Jul 25, 2011 10:42 pm
- Location: East Kent
Re: Shank help
Hair of the dog, bacon, butty.
Hops, cider pips & hello.
Name the Movie + song :)
Hops, cider pips & hello.
Name the Movie + song :)
-
AnthonyUK
Re: Shank help
I can confirm that #JGPI451215F is the correct part as I am using these on the Perlick 650SS shanks.barneey wrote:http://www.themaltmiller.co.uk/index.ph ... ductId=708
I ordered from here - http://www.cotswoldengineeringsupplies.co.uk
Re: Shank help
Fantastic, thanks so much for the help and advice. 