As the title really, I'm looking for a tap with a male thread on the tank side to fit into a female bulkhead i have for my new 120l electric boiler.
Also Im looking at solutions to install a cooling coil through the lid of a 100l insulated thermos pot I've just bought so i can use it as a fermenter. All help gratefully received.
1/2 bsp tap with male end on tank side
-
- Lost in an Alcoholic Haze
- Posts: 638
- Joined: Tue Jan 06, 2015 2:12 pm
1/2 bsp tap with male end on tank side
https://rover.ebay.com/rover/0/0/0?mpre ... 2038859519
Have you purchased the coil already?
Sent from my iPhone using Tapatalk Pro
Have you purchased the coil already?
Sent from my iPhone using Tapatalk Pro
Sabro Single Hop NEIPA 25/02/20 CLICK ME to monitor progress with Brewfather & iSpindel
- Jocky
- Even further under the Table
- Posts: 2738
- Joined: Sat Nov 12, 2011 6:50 pm
- Location: Epsom, Surrey, UK
Re: 1/2 bsp tap with male end on tank side
You could just use a regular tap with a running or barrel nipple?
Ingredients: Water, Barley, Hops, Yeast, Seaweed, Blood, Sweat, The swim bladder of a sturgeon, My enemies tears, Scenes of mild peril, An otter's handbag and Riboflavin.
-
- Lost in an Alcoholic Haze
- Posts: 638
- Joined: Tue Jan 06, 2015 2:12 pm
Re: 1/2 bsp tap with male end on tank side
Hi thanks for the replies, ideally i want as little as possible metalwork wise, i have straight nipples, but its just another thing to keep clean. Thanks for the link, I have one of them on order from aliexpress, i was hoping to find a 3 piece one if possible ? The coil is probably going to be a product coil from a maxi type chiller, i have a couple knocking about.
Re: 1/2 bsp tap with male end on tank side
Then measure your OD of the pipe with a vernier gauge and use a compression fitting and a socket with the lid sandwiched in between.
Sent from my iPhone using Tapatalk Pro
Sent from my iPhone using Tapatalk Pro
Sabro Single Hop NEIPA 25/02/20 CLICK ME to monitor progress with Brewfather & iSpindel
-
- Lost in an Alcoholic Haze
- Posts: 638
- Joined: Tue Jan 06, 2015 2:12 pm
Re: 1/2 bsp tap with male end on tank side
just in case anyone else is looking for 3 piece taps with a male thread homebrewbuilder sorted me out