Gas Feed Into Regulator

[far9410]

If I'm looking at this correctly, there isn't a high pressure gauge in the picture, this is a bank of secondary regs to distribute different pressures to a number of kegs . So there must be another reg fitted to the bottle. So no need to re arrange the gauges , just feed in from the primary, whichever side you choose.

[jmc]

If I'm looking at this correctly, there isn't a high pressure gauge in the picture, this is a bank of secondary regs to distribute different pressures to a number of kegs . So there must be another reg fitted to the bottle. So no need to re arrange the gauges , just feed in from the primary, whichever side you choose.

Gauge on right goes up to 250 bar. Looks like a high pressure gauge to me


However as its not up to pressure hard to tell if CO2 isn't regulated before it gets to gas management board.

You can still lose a bottle of CO2 to a leak on the low pressure side ( ) so I wouldn't risk moving gauges for neatness reasons

[far9410]

My pic only shows the two on left and half of the one on right, I assumed they were all same, as are mine.

[Addled Jim]

[URL=http://s1169.photobucket.com/user/ ... .jpg[/img][/url]
A better picture, I'm just going to mount it vertically - thanks for the replies

[far9410]

Aaah, it all makes sense