200L Brewery (The new, NEW plan)

[haz66]

Pop in anytime you want.
I`ve just finished working up near where you work, we just did the new Caw Ingedient Factory at Leeming Bar, boy i`m glad
i`m not travelling up there everyday, but i enjoyed the job, its one hell of a plant.

[haz66]

P.s is that a nice Marin, hung up - getting dusty?

Yes its a 2006 Marin Rock Springs,that doesn`t get as much use as it should,
due to me building the brewery, but it will be getting a run out up Scotland soon.

[haz66]

I`ve finally finished all the stud work, apart from the pieces to screw the electric socket fittings to, which is todays job,
along with getting the insulation, i`ve ordered white foam PVC sheets to line it all out, they will be delivered the middle of this
week, so hopefully by next weekend we will nearly be there









I actually forget to take some photos after it was all finished, as the above ones only show it half done

[willike]

I can only dream of having space to do this

[haz66]

I can only dream of having space to do this

It will be tight but if my calculations are correct it should just be big enough,
i wish i had had more space to start with but i`ll just have to make do and try not
to swing any cats around

[willike]

I can only dream of having space to do this

It will be tight but if my calculations are correct it should just be big enough,
i wish i had had more space to start with but i`ll just have to make do and try not
to swing any cats around

Always need room to swing a cat.

[haz66]

A few more photos

[haz66]

Started on the insulation


And then on lining it.










I had to stop there as i had a slight water leak and the next boards would have covered the water
pipes so had to hold off.
But on the way home from work today i got the required fittings and its now been sorted,
so hopefully i`ll get a few more boards on tomorrow.

[jamesb]

Where did you get the white sheets from, and more to the point, were they expensive?

[haz66]

Where did you get the white sheets from, and more to the point, were they expensive?

I got them off Ebay,they were £150 for 10 delivered after a bit of negotation
they are 3mm PVC Foam sheets 2440mm X 1220mm.
If you want the sellers details PM me and i`ll PM them to you

[haz66]

Another,almost full weekend working on the conversion.
I now have the light working ,i still need to wire the sockets back into the mains, next weekends job.

Almost there






I`ll get the floor painted over a few evenings during the week, electrics on Saturday,
then i can start moving the shinys in

[rick_huggins]

Looking good Mark, what's behind the Deuchars beer mat though?

[haz66]

Looking good Mark, what's behind the Deuchars beer mat though?

I knocked it off the wall earlier and through it onto one of the taps

[ilsonbok]

That looks great Haz keep em coming where did u get ya pump from!!

[haz66]

That looks great Haz keep em coming where did u get ya pump from!!

Its not a beer tap its a water tap , it`s there to fill the HLT.