6.7mm tubing

The forum for discussing all kinds of brewing paraphernalia.
Post Reply
User avatar
Goosey
Piss Artist
Posts: 178
Joined: Fri Jul 19, 2013 9:29 am
Location: SW France
Contact:

6.7mm tubing

Post by Goosey » Tue Aug 09, 2022 9:38 am

Anyone know where I can get some tubing with an outside diametre of 6.7mm? I need it to fit very snugly inside some tubing of the same interior size.
Last edited by Goosey on Tue Aug 09, 2022 2:30 pm, edited 1 time in total.

f00b4r
Site Admin
Posts: 1528
Joined: Fri Jul 11, 2014 10:54 pm
Location: Berlin

Re: 6.7mm tubing

Post by f00b4r » Tue Aug 09, 2022 12:26 pm

If you cannot find it then you can also get connectors (stainless steel and other materials depending on application) to join different sized tubing.

User avatar
Goosey
Piss Artist
Posts: 178
Joined: Fri Jul 19, 2013 9:29 am
Location: SW France
Contact:

Re: 6.7mm tubing

Post by Goosey » Tue Aug 09, 2022 1:40 pm

Yes, connectors or just short lengths of rigid tubes would do.

User avatar
MashBag
Even further under the Table
Posts: 2140
Joined: Wed Oct 23, 2013 7:13 am

Re: 6.7mm tubing

Post by MashBag » Tue Aug 09, 2022 3:10 pm


User avatar
IPA
Under the Table
Posts: 1731
Joined: Wed Dec 07, 2011 9:29 am
Location: France Gascony

Re: 6.7mm tubing

Post by IPA » Wed Aug 10, 2022 7:49 am

I have some 7.2 OD if that is any use

Ian
"You're not drunk if you can lie on the floor without holding on." Dean Martin

1. Life is not a journey to the grave with the intention of arriving safely in a pretty and well-preserved body, but rather to skid in sideways, thoroughly used, totally worn out and loudly proclaiming... "f*ck, what a trip

It's better to lose time with friends than to lose friends with time (Portuguese proverb)

Alone we travel faster
Together we travel further
( In an admonishing email from our golf club)

User avatar
Goosey
Piss Artist
Posts: 178
Joined: Fri Jul 19, 2013 9:29 am
Location: SW France
Contact:

Re: 6.7mm tubing

Post by Goosey » Wed Aug 10, 2022 8:37 am

Thanks Ian, but I'm trying to make a small valve for my cubitainers so they can let off gas in their own time :)
I've got a ball bearing pushing a spring inside a piece of tubing. The 6.7 mm tube needs to fit very snugly inside this tube as the ball bearing closes off the gas when pushed against it.

Post Reply