Britvic 3 Stage Co2 Management System

[46philh]

Will this be ideal to use ?

Britvic 3 Stage Co2 Management System

http://www.ebay.co.uk/itm/Pub-Gauges-Br ... 1159806237

[Mr. Dripping]

Looks a nice compact gas management board that you should be able to use without a problem
Hook up you gas bottle to the inlet and then you can connect 3 cornys with the bonus of being able to set them at individual pressures.

[Belter]

Looks the same as mine but with taps and mounted On a backing plate. Mine is great. Now thinking I need some taps.

[Fil]

[/url]

been using mine a couple of years.. i had to service the on off valves on the outputs, ( strip clean and replace washers and use gas tape on the threads if u undo anything) and always check a pressure 20 mins after setting, mine can creep up in pressure over time needing a tweak back,

i use 2 lines for kegging pressures and the 3rd is connected to an airgun for flushing vessels bottles and kegs with co2 prior to filling

[Mr. Dripping]

....... the 3rd is connected to an airgun for flushing vessels bottles and kegs with co2 prior to filling

Any chance you could post a picture of that please Fil, I'd like to set up something similar.
TIA

[jmc]

....... the 3rd is connected to an airgun for flushing vessels bottles and kegs with co2 prior to filling

Any chance you could post a picture of that please Fil, I'd like to set up something similar.
TIA

Another option:
Connect Pub CO2 to Tyre Inflator

[46philh]

[/url]

been using mine a couple of years.. i had to service the on off valves on the outputs, ( strip clean and replace washers and use gas tape on the threads if u undo anything) and always check a pressure 20 mins after setting, mine can creep up in pressure over time needing a tweak back,

i use 2 lines for kegging pressures and the 3rd is connected to an airgun for flushing vessels bottles and kegs with co2 prior to filling

I could do with replacing the connector & gas line from them board to the gas bottle on mine. Any idea what parts I need to replace them ?

[Fil]

The air gun is in the pic i posted its draped over the regs and is attached to the long loop of gasline from the central reg.

one like this http://www.ebay.co.uk/itm/6PC-Air-Blow- ... 2ecc48ad77
with a 3/8" jg to 1/4" bsp male to screw into the air gun rear connected to 3/8" gas line... i should coil it up neater..


Replacing the hi pressure gas feed hose from the bottle is doable with a lot of muscle and a long lever the threaded connections are sealed with something making breaking the seal a real sod. i used a 30cm monkey wrench and a 4 ft length of steel pipe as a lever while a pal put pressure onto the back plate and wall to stop me ripping it off/bending it..

I got my replacement hose from a member in here with a spare.. Norm of corny fame may be able to supply one, as to the actual name?? i call it 'the hi pressure bottle connecting hose'??
its a one piece job so thats all u need plus some gas sealing tape to secure the connection to the board.

[edonald774]

Deleted cause it was me. I hadn't turned the gas on.